Pioneer DEH-X2600UI Car Stereo System User Manual


 
Black plate (5,1)
Selecting a source
1 Press SRC/OFF tocycle between:
RADIOCDUSB/iPodPANDORAAPP
(application)AUX
! USB MTP displayswhile the MTP connection
is in use.
! Only for DEH-X2600UIand DEH-X26UI
When there isan iPod connected anda source
other than iPodis selected, you canswitch to
iPod by pressingiPod.
Adjusting the volume
1 Turn M.C.to adjust the volume.
Note
When this units blue/white lead is connected to
the vehicles auto-antenna relay control termi-
nal, the vehicles antenna extends when this
units source is turned on. To retractthe anten-
na, turn the source off.
Use and care of the remote
control
Using the remotecontrol
1 Point the remotecontrol in the directionof the
front panel tooperate.
When using forthe first time, pullout the film
protruding from thetray.
Replacing thebattery
1 Slide the tray out onthe back of theremote
control.
2 Insert the battery with the plus(+) and minus
() poles alignedproperly.
WARNING
! Keep the battery out of the reach of children.
Should the battery be swallowed, consult a
doctor immediately.
! Batteries (battery pack or batteries installed)
must not be exposed to excessive heat such
as sunshine, fire or the like.
CAUTION
! Remove the battery if the remote control is
not used for a month or longer.
! There is a danger of explosion if the battery is
incorrectly replaced. Replace only with the
same or equivalent type.
! Do not handle the battery with metallic tools.
! Do not store the battery with metallic ob-
jects.
! If the battery leaks, wipe the remote control
completely clean and install a new battery.
! When disposing of used batteries, comply
with governmental regulations or environ-
mental public institutions rules that apply in
your country/area.
! Perchlorate Material special handlingmay
apply.
See
www.dtsc.ca.gov/hazardouswaste/
perchlorate. (Applicable to California,
U.S.A.)
Important
! Do not store the remote control in high tem-
peratures or direct sunlight.
! The remote control may not function properly
in direct sunlight.
! Do not let the remote control fall onto the
floor, where it may become jammed under
the brake or accelerator pedal.
Frequently used menu
operations
Returning to theprevious display
Returning to theprevious list (thefolder one level
higher)
1 Press
/DIMMER.
Returning to theordinary display
Canceling the mainmenu
1 Press BAND/
.
Returning to theordinary display from the list
1 Press BAND/
.
Radio
Basic operations
Selecting a band
1 Press BAND/
until the desiredband (FM1,
FM2, FM3 forFM or AM) isdisplayed.
Switching preset stations
1 Press c ord.
! Select PCH (presetchannel) under SEEK to
use this function.
! Use the aand b on theremote control to
switch between presetstations.
Manual tuning (stepby step)
1 Press c ord.
! Select MAN (manualtuning) under SEEK to
use this function.
Seeking
1 Press and holdc or d, andthen release.
You can cancel seektuning by briefly pressing
c or d.
While pressing andholding c or d, you can
skip stations. Seektuning starts as soonas
you release cor d.
Note
For details about SEEK, refer to SEEK (left/right
key setting) on page 6.
Storing and recalling stations
for each band
Using preset tuning buttons
1 To store: Press and hold down one of the
preset tuning buttons (1/
to 6/ )until
the number stops flashing.
2 To recall: Press one of the preset tuning
buttons (1/
to 6/ ).
Switching the display
Selecting the desiredtext information
1 Press DISP tocycle between the following:
! FREQUENCY (program service nameor
frequency)
! BRDCST INFO (songtitle/artist name)
! CLOCK (source nameand clock)
Notes
! If the program service name cannot be ac-
quired in FREQUENCY, the broadcast fre-
quency is displayed instead. If the program
service name is detected, the program serv-
ice name will be displayed.
! Depending on the band, text information can
be changed.
! Text information items that can be changed
depend on the area.
Function settings
1 Press M.C. to display the main menu.
2 Turn M.C. to change the menu option
and press to select FUNCTION.
English
Using this unit
5
Section
Using this unit
En
02
<QRD3201-A>5