Filter
Top Products
Installation
En
13
English
Español
Deutsch
Français
Italiano
Nederlands
DIN Front-mount
Installation with the rubber bush
Removing the unit
Holder
After inserting the holder into the
dash-board, then select the
appropriate tabs according to the
thickness of the dash-board
material and bend them.
(Install as firmly as possible using
the top and bottom tabs. Tosecure,
bend the tabs 90 degrees.)
182
53
Rubber bush
Screw
Dashboard
Frame
Insert the release pin into the hole
in the bottom of the frame and pull
out to remove the frame. (When
reattaching the frame, point the
side with a groove downwards and
attach it.)
Insert the supplied extraction keys into the
unit, as shown in the figure, until they click
into place. Keeping the keys pressed against
the sides of the unit, pull the unit out.