Filter
Top Products
<CRD3539-A>34
08
Section
En
34
Initial Settings
Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for this unit.
1 FUNCTION display
Shows the function status.
1 Press SOURCE and hold until the unit turns
off.
2 Press FUNCTION and hold until A-PI
appears in the display.
3 Press FUNCTION to select one of the initial
settings.
Press FUNCTION repeatedly to switch between
the following settings:
A-PI—WARN—AUX—DIMMER—ILL.CLR —
FRT+REAR
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press BAND/ESC.
• You can also cancel initial settings by holding
down FUNCTION until the unit turns off.
Switching auto PI seek
The unit can automatically search for a different
station with the same programming, even dur-
ing preset recall.
1 Press
FUNCTION to select A-PI.
Press
FUNCTION repeatedly until A-PI appears
in the display.
2 Select A-PI
on or off with 5/∞.
Pressing 5/∞ will switch
A-PI between on and
off and that status will be displayed (e.g.,
A-PI :ON).
Switching the warning tone
If the front panel is not detached from the head
unit within five seconds of turning off the igni-
tion, a warning tone will sound. You can turn off
this warning tone.
1 Press FUNCTION to select WARN.
Press FUNCTION repeatedly until WARN
appears in the display.
2 Select WARN on or off with 5/∞.
Pressing 5/∞ will switch WARNbetween on
and off and that status will be displayed (e.g.,
WARN :ON).
1
CRD3539A_Eng 9/21/01 4:44 PM Page 34