Pioneer PRS-A500 Car Amplifier User Manual


 
Specifications
Power source .......................................................................................................... 14.4 V DC (10.8 — 15.1 V allowable)
Grounding system .......................................................................................................................................... Negative type
Current consumption ........................................................................................................ 25 A (at continuous power, 4 )
Average current drawn* ........................................................................................................ 8.5 A (4 for two channels)
14.2 A (4 for one channel)
Fuse ........................................................................................................................................................................ 20 A × 2
Dimensions ...................................................................................................................... 300 (W) × 63 (H) × 330 (D) mm
Weight .................................................................................................................... 5.8 kg (Leads for wiring not included)
Maximum power output .................................................................................................................. 200 W × 2 / 600 W × 1
Continuous power output ............................................................ 100 W × 2 (at 14.4 V, 4 , 20 — 20 kHz 0.08% THD)
300 W × 1 (at 14.4 V, 4 , 20 — 20 kHz 0.8% THD)
150 W × 2 (at 14.4 V, 2 , 20 — 20 kHz 0.8% THD)
Continuous power output (DIN power) ................................................ 140 W × 2 / 500 W × 1 (DIN45324, +B=14.4 V)
Load impedance .......................................................................................................................... 4 (2 — 8 allowable)
(Bridge connection: 4 — 8 allowable)
Frequency response ........................................................................................................ 10 Hz — 80 kHz (+0 dB, –1 dB)
Signal-to-noise ratio .................................................................................................................... 107 dB (IEC-A network)
Distortion ........................................................................................................................................ 0.003 % (10 W, 1 kHz)
Separation .................................................................................................................................. 70 dB (100 Hz — 10 kHz)
Slew rate.............................................................................................................................................................. 40 V/µ sec.
Damping factor .............................................................................................................................................................. 100
Low pass filter ................................................................................................................ Cut off frequency: 40 — 120 Hz
Cut off slope: –12 dB/oct
High pass filter.................................................................................................................. Cut off frequency: 40 — 120 Hz
Cut off slope: –12 dB/oct
Gain control .............................................................................................................................................. 200 mV — 6.5 V
Maximum input level / impedance ...................................................................................................... RCA: 6.5 V / 22 k
Note:
Specifications and the design are subject to possible modification without notice
due to improvements.
*Average current drawn
The average current drawn is nearly the maximum current drawn by this unit
when an audio signal is input. Use this value when working out total current
drawn by multiple power amplifiers.
10
ENGLISH ESPAÑOL DEUTSCH FRANÇAIS
ITALIANO NEDERLANDS