Filter
Top Products
35
En
9Using the Timer
Using the sleep timer
The sleep timer switches the system into standby after a
specified amount of time so that you can fall asleep
without worrying about the stereo being left on all
night. If you've also set the wake up timer this is
important since the wake up timer will only work if the
system is in standby.
1 Press SLEEP (SHIFT & 6) to set the time
until the system goes into standby.
Press repeatedly to switch between:
•
SLEEP AUTO – this setting is only available when
the system is playing a CD*
•
SLEEP 90 (minutes)
•
SLEEP 60 (minutes)
•
SLEEP 30 (minutes)
•
SLEEP OFF (cancels the sleep timer)
The sleep timer indicator (
) lights and the display
dims when the sleep timer is active.
* This is not available when a Video CD is in PBC mode,
or if you're playing a CD or Video CD in repeat mode. If
you set a disc playing in repeat mode after setting the
sleep timer to
SLEEP AUTO, it automatically switches
to the 90 minute setting.
• Once the sleep timer is set, you can check the time
left by pressing
SLEEP (SHIFT & 6).
• To cancel the sleep timer, switch the system into
standby, or select
SLEEP OFF (as described above).
• If you switch to a different source when sleep auto is
set, the system will automatically go into standby a
minute later.
Checking the timer settings
If you’ve set the wake-up timer, you can check the
settings anytime.
1 Press SYSTEM SETUP.
2 Press 2 or 3 until you see TIMER in the
display.
3 Press ENTER.
4 Press the 2 or 3 button until you see
TIMER CHECK in the display.
5 Press ENTER.
The display shows the timer settings:
• On time
• Off time
• Function (DVD, etc.)
• Volume
•
CHECK END