Filter
Top Products
14
Wall-mount instruction
Preparing To Install The Optional Wall Mount Arm (not included)
This TFT LCD Monitor can be attached to a wall mounting
arm you can purchase separately.
Turn the power OFF then disconnect the cables from the
TFT LCD Monitor before performing the procedure below.
1. Lay the TFT LCD Monitor face down on a soft surface.
2. Remove the 4 screws holding the stand to the hinge.
3. Remove the stand.
Attaching The Optional Wall Mount Arm (not supplied)
Follow these steps to nish installing the wall mounting
arm:
1. Place the wall mounting arm onto the back of the
TFT LCD Monitor. Line up the holes of the arm with
the holes in the back of the monitor.
2. Insert the 4 screws into the holes and tighten.
3. Reconnect the cables. Refer to the User’s Guide
that came with the optional wall mounting arm for
instructions on attaching it to the wall.
NOTE
●
100 mm x 100 mm VESA high hole (n=4), M4, pitch =0.7 mm
screw mounting kit not included.
100mm
100mm
100mm x 100mm Screw
Mounting Options
4mm, 0.7 pitch
threaded holes x 4
1
2
3