Filter
Top Products
ELECTRICAL AND SIGNAL CONNECTIONS
Before making the following connections, take time to look over the vehicle’s wiring and
determine the location and wires you will be connecting to. If you do not wish to cut or tap into
the vehicles existing factory wiring, there are wiring kits available at your car audio retailer
that will allow you to plug directly into the factory wiring harness. Make sure to test all wires
before connecting to the CD Player.
!
Connect Black wire to chassis ground.
!
Connect the Violet memory backup wire to a Constant +12 Volt power source wire.
!
Connect the Red ignition wire to an accessory +12 Volt power source wire. (The power
wire that is energized when the key is in the accessory position).
!
The White wire is connected only if a power antenna or an amplifier is used in the
system. This wire supplies +12 Volt output when the CD Player is turned on,
which activates most power antenna relays or amplifier turn on circuits.
5
RED
RED
VIOLET
VIOLET
CONSTANT
+12V
SWITCHED +12V
(ON WITH IGNITION)
+12V REMOTE OUTPUT
FOR AMPLIFIER TURN-ON
OR POWER ANTENNA
BLACK
BLACK
BATTERY
+12V
FRONT RIGHT
SPEAKER
(4 OHM)
FRONT LEFT
SPEAKER
(4 OHM)
LOW LEVEL SIGNAL OUTPUT
FOR CONNECTION TO
AMPLIFIERS OR SIGNAL
PROCESSORS
ANTENNA
CONNECTOR
REAR LEFT
SPEAKER
(4 OHM)
REAR RIGHT
SPEAKER
(4 OHM)
BROWN
GREY
WHITE
WHITE
BLACK/WHITE
BLUE
YELLOW
ORANGE
GREEN
PINK
FU
SES
LEFT CHANNEL (WHITE)
LEFT CHANNEL (WHITE)
FRONT
RCA’S
BLACK
WIRES
GREY
WIRES
REAR
RCA’S
RIGHT CHANNEL (RED)
RIGHT CHANNEL (RED)
FOUR SPEAKER SYSTEM
FUSES
15A (VIOLET WIRE)
1A (RED WIRE)