Mono channel amplifier
system wiring
4
features and controls
5
Class-D MONO BLOCK AMPLIFIER PLMRA1000D
PLMRA1000D
Class-D MONO BLOCK AMPLIFIER PLMRA1000D
Low-frequency information for subwoofer only.High efficient power
Stiffly regulated PWM power supplies. MOSFET switches maintain
rated power over a wide range of battery voltages.
Adjustable from 20Hz to 250Hz with a slope of 24dB per octave.This
allows for the adjustment of the upper point of the frequency bandwidth
and the respective subwoofer.
Adjustable from 15Hz to 40Hz with a slope of 24dB per octave.This allows
for the attenuation of frequencies that are mostly inaudible and cause
unnecessary strain on the amplifier.
Protection against thermal, overload and short circuit conditions.
This amplifier come complete with a compact remote GAIN CONTROLLER
which can be conveniently mounted on or under the dashboard of your
car.
Class-D design
power supplies
crossover low pass filter
high pass subsonic filter
protection circuitry
remote dash-mount gain control
power supply voltage
input sensitivity
20Hz-250Hz( 3dB)
250mV~4V Adjustable
14.4V DC Neg.ground(10.5-16V)
dimensions (W x H x L)
mm
inches
input impedance
10K Ohms
10.9 x 2.7 x 12
RMS Power at @4 Ohms
RMS Power at @2 Ohms
RMS Power at @1.3 Ohms
Maximum Power Outputs
200W MONO
400W MONO
1000W MONO
2000W MONO
frequency response
output power @14.4v DC,50KHz
1 Ohm
min speaker Impedance
T.H.D
0.1%
S/N ration
>90dB
fuse
20A x 2
276x69.5X305
SIGNAL INPUT AND BYPASS OUTPUT CONNECTION
SPEAKER OUTPUT CONNECTION
+
-
PLMRA1000D