Filter
Top Products
5. LCD (LIQUID CRYSTAL DISPLAY)
8. LOUD/SUB WOOFER BUTTON
press it shortly to enhance the bass effect during bass mode.
Press it more than 2 seconds, SUB WOOFER will be turned on.
then press SEL button to select the sound mode such as volume, bass,
treble, balance and fader, and then press + or - button to increase or
decrease the volume level of the selected sound mode. Press it more
than 2 seconds again to turn off the SUB WOOFER.
9. OPEN BUTTON
Press it to flip the panel down from the unit. But you can't take the panel
away because it is still linked with the unit by metal plates.
10.MUTE BUTTON
Press it to eliminate the sound immediately.
11.DISPLAY BUTTON
Press it repeatedly to turn on the preset equalizer curves: FLAT, POP,
CLASSIC and ROCK, and the sound quality will be changed.
TROUBLE SHOOTING
Before going through the check list, finish wiring connection. If there still are
any question after finish testing the items in the following list, consult your
nearest service dealer.
Symptom Cause
The fuse is blown. Replace the fuse with another 15A
fuse.
Switch the ignition to the "ON" or
"ACC" position.
No power.
Select a station using manual tuning.The signals are weak.
The radio does
not stop on any
stations when
automatic
tuning is used.
Insert the antenna cable firmly into
the antenna jack on the unit.
The antenna cable is not
connected.
No radio
reception.
Turn the power off and then on
again.
Eject the disc or tape, then insert it
again.
The microcomputer has been
affected by electrical noise.
The unit does
not work
properly (Eject,
Load, Play).
The vehicle ignition is switched
off.
Clean the disc.
The disc is dirty.
Try another disc. If it plays properly,
the first disc may be defective.
The disc is defective.
Install the unit securely. Be sure to
use the rear strap if the vehicle
does not provide support for the
rear of the unit.
The unit is not mounted
securely.
Wait for the road surface to
improve before playing a disc.
The road surface is rough.
The sound from
the CD player
skips.
Check the +12V and ground
connections.
The power connections are not
wired correctly.
The volume control is turned
down.
The compact
disc or tape
does not play
when inserted
into the unit.
Solution
Turn up the volume control.
6. BAND BUTTON
Press it to switch from tape, CD or CDC mode to radio mode, then press it
repeatedly to select the band and the LCD screen will be shown as below:
FM 1 FM 2 FM 3 AM 1 AM 2
7.21. TUNE/SEEK/TRACK UP OR DOWN, FF/RW BUTTONS
In radio mode, press UP or DN button shortly to start automatic tuning
and stop at the next receivable station; press UP or DN button for more
than 2 second to change into manual tuning mode.
In tape mode, press UP or DN button to fast forward or rewind the tape,
and press TAPE button to resume normal tape playing.
In CD player mode, press UP or DN button to skip to the beginning of
the next track or one of the track currently playing. Press the DN button
twice to skip to the beginning of the previous track. Press and hold UP or
DN button for more than 2 seconds to search quickly (with sound) in the
forward or reverse direction.