Filter
Top Products
Installation
26
Installing the Unit
1. Place the universal mounting bracket (Half Sleeve) into the instrument panel and bend
each stopper of the mounting bracket inward by a screwdriver.
2. Insert the unit into the mounting bracket until it locks after connecting the wires.
3. Mount the outer escutcheon so that all the hooks are looked.
Removing the unit
1. Unfasten the hex nut when the rear of the unit has been secured with it.
2. Remove the outer escutcheon.
3. Insert the 2 keys as the figure between the spring and the mounting bracket,
then pull the unit out.
*Keep the 2 keys in safe. You cannot remove the unit without it.
1. Make sure to ground the unit to a negative 12V DC power supply
2. When replacing a fuse, only use a new one with the prescrived rating. Using a fuse with wrong
rating may cause the unit to malfunction.
3. To prevent short circuits when replacing a fuse, first disconnect the wiring harness.
4. Do not use any screws except for the ones provided. Using improper screws may damage the unit.
5. If you experience problems during installation, consult your supplier.