Filter
Top Products
Page 09
Before going through the check list, check wiring connection. If any of the presist after checklist
has been made, consult your nearest service dealer.
No Power
CD Cannot Be
Loaded or Ejected
No Sound
Sound Skipping
The Operation Keys
Do Not Work
The Radio or
Automatic Selection
Does Not Work
The car ignition key has not
been switched on
The fuse is blown
A CD is already inside the
player slot
Inserting the CD in reverse
direction
The CD is extremely dirty or
defected
Temperature inside the car is
too high
Condensation
Volume is at minimum
Wiring is not properly
connected
The installation angle is more
than 30°
CD is extremely dirty or
defected
The built-in microcomputer is
not operating properly due to
interference
The antenna cable is not
connected correctly
The signals are too weak
If the power supply is properly
connected to the car accessory
terminal, switch the ignition
key to ACC.
Replace a new fuse
Remove the CD from the player
and insert the new one
Insert the CD with the label
facing up
Clean the CD or try to play
a new one
Cool off until the ambient
temperature return to normal
Leave the player off for an
hour or so and try again
Adjust volume to desired level
Check wiring connection
Adjust the installation angle to
less than 30°
Clean the CD or try to play
a new one
Press the RESET button or
reinstall the front panel
properly
Connect the antenna cable
correctly
Select the station manually
Symptom
Causes
Solution
06 TROUBLESHOOTING