Filter
Top Products
2) Press the + button or - button to increase or decrease the sound level of
2) Press the + button or - button to increase or decrease the sound level of
left or right speaker.
front or rear speaker.
5. LCD ( LIQUID CRYSTAL DISPLAY)
7. TUNE SEEK UP/DOWN, TRACK UP/DOWN BUTTONS
During RADIO mode, press UP or DN button to seek up or down for the
desired station. Press UP or DN button hold for more than 2 seconds to
scan up or down for the stronger station.
During CD mode, Press the UP or DN button to allow you to track forward
or backward. Press UP or DN button hold to skip forward or backward.
8. POWER BUTTON
Press the button to turn on or off the unit.
9. BAND/LOUD BUTTON
Press it to select your desired radio band and word which band is selected
will be displayed on LCD.
FADER CONTROL
1) Press the SEL button to select the fader mode until FAD appears on the display.
TROUBLE SHOOTING
Go through the check list if you are in trouble during operation. If any
problem persist after going though the check list, consult your nearest
service dealer.
Symptom
No power
Disc cannot
be loaded or
ejected
Cause
The fuse is blown
Presence of CD disc inside
the player
Inserting the disc in upside
down
Compact disc is extremely
dirty or defective
Temperature inside the
car is too high
Condensation
Volume is in minimum
No sound
The operation
keys do not
work
Sound skips
The antenna cable is not
connected
the signals are too weak
Insert the antenna cable firmly
select a station manually
The radio does
not work
the radio
station
automatic
selection does
not work
The built-in microcomputer
is not operating properly
due to noise
Press the RESET button
front panel is not properly
fix into its place
Wiring is not properly
connected
The installation angle
is more than 30 degrees
The disc is extremely
dirty or defective
Clean the compact disc/try to
play a new one
Adjust the installation angle
to less than 30 degrees
Adjust volume to a desired level
Check wiring connection
Leave the player off for an
hour or so, then try again
Cool off until the ambient
temperature returns to normal
Clean the disc or try to play a
new one
Insert the compact disc with
the label facing upward
Remove the disc in the player
then put a new upward
Replace the fuse
The car ignition is not on. If the power supply is properly
connected to the car accessory
switch the ignition key to " ACC "
Solution
6. MUTE BUTTON
Press it to eliminate the sound immediately.
4
7
10.CLOCK ADJUSTMENT BUTTON
During frequency display, press it to change to clock display function.
Press the button for more than 2 seconds, until time flashes, then press
UP or DN button to adjust hour or minute.
11.MODE BUTTON
Press it to switch between 4 preset equalizer curves: FLAT, CLASSIC, POP
and ROCK, and the sound quality will be changed.
13.PRESET STATION [ 1-6 ] /1PUS, 2SCN, 3RPT, 4SHF.
A]. To memorize the current frequency, press any one of the six preset
buttons hold for more than 2 seconds.
B]. To recall the preset memory, press one of the preset button [1-6].
C). In CDP mode, press 1PUS button to pause CDP playing, press it again to
resume CDP playing.
Press it repeatedly to select CDP, AUX and RADIO mode in sequence and
circulation.
12.DSP BUTTON
Press it hold for more than 2 seconds to enhance the bass sound effect.