Filter
Top Products
Page. 4
P / N : 570-981853-02
P / N : 570-981853-02
RESET FUNCTION
INSTALLATION
UNIT REMOVAL
1. Remove Front Control Panel.
2. Slightly insert the key into the slot and
gently to release.
3. Separate the sleeve from the unit. Keep
release key in a safe place as you may
need for future removal of unit.
REMOTE CONTROL
WIRE CONNECTION
CAUTION : Do not connect the speaker wires to
chassis or car body. Each speaker wire cannot be
soldered together with other wires. Otherwise, the
unit will be damaged and no sound will come out
anymore.
CAUTION : DO NOT PLACE THE UNIT OVER THE
MAXIMUM INSTALLATION ANGLE OF 30°.
OTHERWISE, THE UNIT MAY NOT WORK
PROPERLY.
WARNING!!
Due to protection of CD Mechanism, two small screws on the top
of the unit must be released before operate the unit. Otherwise, the
CD Mechanism can not be working properly.
The RESET button is located at the back of the panel. It is
recessed in order to prevent accidental engagement, and
can be activated with the tip of a ball-point pen or any
similar pointed object. This reset circuitry is provided in
order to protect the unit's microprocessor, and should only
be activated under the following conditions :
a) Initial installation after all wiring is completed.
b) Abnormal operation is encountered such as numerical
indication on display is erratic.
c) Whenever the reset button is activated, all preset
memory content will be erased and must be
reprogrammed.