Filter
Top Products
3. INSTALLATION
1. Rotate the locking knob on the neck of the
mounting stand clockwise.
2. Slide the engagement head on the mounting
stand into the slide bracket slot on the rear of
the monitor housing.
3. Rotate the locking knob counterclockwise
until it is hand-tight and the monitor is securely
fastened to the neck of the mounting stand.
4. Locate a desirable spot in your vehicle for the
monitor. Hold it place there, with the mounting
plate resting in approximately the right location
and have a friend sit in the seat from which you
intend viewing of this monitor to take place to
confirm the location of the monitor. If necessary,
loosen the angle adjustment knob and rotate the
monitor to a more ideal angle and retighten.,
5. Once you have confirmed the location of the
monitor, remove the adhesive backing from
the underside of the mounting plate and firmly
press all the "petals" of the mounting plate
down to the car surface. Temporarily remove
the monitor by loosening the locking knob, and
use three screws in the locations indicated in
the drawing below to further secure the monitor
mounting plate. If necessary, drill pilot holes to
assist in inserting the screws.
6. Reinstall the monitor onto the neck of the mounting
stand and tighten the locking knob. Adjust the monitor
angle again as required, being sure to tighten the angle
adjustment knob when you are done.
2