RCA ANT751 Car Stereo System User Manual


 
Make sure to place the leads of the matching
transformer between the two washers on
each post as shown here.
&INALLYTIGHTENTHEHEXNUTSTOSECURETHELEADS
Step 6: Insert end caps
Insert the plastic end caps in the ends of the
booms as shown here. Use a rubber mallet to
gently tap them into the antenna booms to
secure them.
Step 7: Attach the mounting pipe to the foot
&INDTHEENDOFTHEMOUNTINGPIPEWITH
holes on the sides for screws. Insert
this end into the middle of the foot as
illustrated here. Then insert the 2-1/2”
screw through the foot and pipe as shown.
3CREWTHEvHEXNUTONTOTHEENDOFTHE
screw to hold the pipe and foot together.
Don’t tighten the nut completely yet.
&INDTHESQUAREHOLESONEITHERSIDEOF
the bottom of the pipe. Raise the pipe
slightly and insert a 5/8” bolt through
these holes and out of the side of the
foot. Install the nuts on the outside
of the foot on the 5/8” bolts to hold
the pipe in place. Don’t tighten the nuts
completely yet.
2 1/2”
screw
Hex nut on
5/8” bolt