Filter
Top Products
EN
9
More Information
CD Lens Care
• When your CD lens gets dirty it can also cause the
system to output poor sound quality. To clean the lens
you will need to purchase a CD lens cleaner which can
maintain the output sound quality of your system. For
instructions on cleaning the CD lens, refer to the ones
accompanying the lens cleaner.
Tape Player
• To prevent deterioration of
sound quality, periodically
open the door of each deck
and clean the magnetic heads,
pinch roller, and capstan with
a cotton bud dipped in alcohol.
• Also, demagnetize the head by playing a
demagnetizing cassette (available through an audio
equipment store).
• To protect your recordings from accidental erasure on
one or both sides of your cassette, snap out the tab at
the top of the cassette. If you decide
later to record on the tape, seal the
hole with a piece of adhesive tape.
(Refer to diagram on the right)
• Quit Slacking - A little bit of slack in your tapes can
cause scratches on the tape, or worse yet,
the tape could break. If you notice some
slack in the tape, use a pencil to tighten it
up before you insert it.
Safety Precautions
• Never open the cabinet under any circumstances. Any
repairs or internal adjustments should be made only by a
trained technician.
• Never operate this product with the cabinet removed.
• Do not touch the player with wet hands. If any liquid
enters the player cabinet, take the player to a trained
technician for inspection.
• This compact disc player uses a laser to read the music
on the disc. The laser mechanism corresponds to the
cartridge and stylus of a record player. Although this
product incorporates a laser pick-up lens, it is completely
safe when operated according to directions.
• Discs rotate at high speed inside the player. Do not
use damaged, warped, or cracked discs.
• Prevent damage to this product, set switch for proper
voltage.
• Do not touch the pick-up lens which is located inside
the disc compartment. Also, to keep dust from
collecting on the pick-up lens and do not leave the
compartment door open for an extended period of time.
If the lens becomes dirty, clean it with a soft brush, or
use an air blower brush designed for camera lenses.
Important Batteries
Information
• Remove the batteries to avoid leakage if you do not
use your remote control for more than one month.
Discard leaky batteries immediately as leaking batteries
may cause skin burns or other personal injuries. Dispose
of batteries in the proper manner, according to
provincial and local regulations. Any battery may leak
electrolyte if mixed with a different battery type, if
inserted incorrectly, if all batteries are not replaced at
the same time, if disposed of in fire, or if an attempt is
made to charge a battery not intended to be recharged.
Headset Safety
• Do not play your headset at a high volume. Hearing
experts are against continuous extended play.
• If you experience a ringing in your ears, reduce volume
or discontinue use it.
• You should use be extreme caution or temporarily
discontinue use it in potentially hazardous situations.
Even if you headset is an open-air type designed to let
you hear outside sounds, don’t turn up the volume so
high that you are unable to hear what is around you.
Information Iabels
They are placed behind and inside the set.
The unit complies with international safety specifications
IEC 65 (VDE 0860) and with European directives, 82/499/
EWG (VDE 0875).
Technical Specifications
• Power supply: 120V~60Hz (for RCA models
only); 230V~50Hz (for Thomson models only)
• Speaker impedance: 8 ohm
• Phone impedance: 32 ohm
• Dimensions (mm): W: 440 - H: 230 - D: 220
• Tape deck: Response curve: 125Hz-8kHz (-5dB)
• CD player: Response curve (+/- 2dB): 20Hz to 20
kHz
• Rating Plate: Look for it at the back of the set.
A
60
A
A
A
A
The descriptions and characteristics in this owner’s manual are for the
purpose of general reference only and not as a guarantee. In order to
provide you with the highest quality product, we may make changes
or modifications without prior notice. The English version serves as the
final reference on all product and operational details should any
discrepancies arise in other languages.
RS1290 2/16/01, 12:00 PM13