Filter
Top Products
9
Connection Examples
Important Notes on Placement
• During setup and transport, be careful not to damage the
vibrating portions (the speaker cone and diaphragm).
• Be sure to place the monitor so that the slits on the top to
radiate the heat is not obstructed. Also, make sure the
monitor does not touch any curtains or other fabrics.
• This unit performs cooling when the monitor is placed as
shown below. Do not place the monitor on its side or
upside down.
fig.
• When this unit is in operation, the top side will become
hot. Take care not to touch it.
• Do not put anything on the unit.
• During operation, this unit must be placed at a distance
of no less than 20 cm (7-7/8 inches) from any walls.
fig.
* Please also refer to “Placement” in
IMPORTANT NOTES
(p.
5).
Precautions When Connecting and Turning on the Power
921
• To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn
off the power on all devices before making any
connections.
941
• Once the connections have been completed, turn on
power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other
devices. (When turning the power off, reverse this
procedure.)
1.
Turn on the power on the devices connected to the
DS-8/7/5.
2.
Turn off the power on the DS-8/7/5.
942
• This unit is equipped with a protection circuit. A brief
interval (a few seconds) after power up is required
before the unit will operate normally.
926a
• When connection cables with resistors are used, the
volume level of equipment connected to the inputs
(Analog Input) may be low. If this happens, use
connection cables that do not contain resistors, such as
those from the Roland PCS series.
Heated Air
no less
than 20cm
(7-7/8 inches)
no less than 20cm
(7-7/8 inches)
no less
than 20cm
(7-7/8 inches)
no less
than 20cm
(7-7/8 inches)
DS-8_7_5_e4.book 9 ページ ２００７年２月２０日 火曜日 午後１時２分