Filter
Top Products
Page 3 Page 4
For instructions on the physical installation of the monitor,
please refer to the directions provided with the trim ring.
Wiring the CV4026 Power Supply Module
Properly fuse all electrical connections. If you have any doubts
about proper fusing, please consult an MECP-certified in-
staller.
The CV4026 module is intended to be installed out of sight
under a seat or behind a trim panel. Make sure that the
module is within the reach of the yellow cable - otherwise, you
won’t be able to connect the module to the monitor!
Yellow - 12V(+) Constant. Connect this wire to a
source of 12V(+) constant voltage. This is often
referred to as BAT (short for battery), or memory.
Red - 12V(+) Accessory. Connect this wire to a
source of 12V(+) that is only powered when the
ignition key switch is in the ACC (accessory) and
RUN or IGN (Ignition) positions.
Black - Chassis Ground. This wire should be
attached to the chassis of the vehicle, to a clean,
unpainted metal surface. It is good installation
practice to ground all system components to the
same point. If you have any questions about what
constitutes a good grounding point, please consult an
MECP-certified installer.
Blue - Optional 12V(+) Switched Output. This wire
provides up to 500mA of 12V(+), and is controlled by
the Speaker button on the monitor. It is intended to
allow user control of an optional FM modulator. FM
modulators allow the vehicle sound system to play
back sound from other devices, such as VCR’s, DVD
players, and MP3 players. See your authorized
Rosen dealer for details.
NOTE: Never ground this wire - module failure will
result!
1 Yellow +12V
2 Blue Remote Out
3 Red Accessory
4 Black Ground
+12V Fuse 3A
Remote Out Fuse 1A
RPN 9000178 REV A
Serial No: YMMLLXXXX
12
34
V A (L) A (R)
AV 2
V A (L) A (R)
AV 1
VA (L)A (R)
OUT
To ClearVue
Monitor
The CV 4026 module uses standard RCA connectors for A/V
(audio/video) inputs. It also has an extra set of RCA A/V
outputs, for connection to an optional second monitor. These
outputs carry the same signals that are routed to the CV II
monitor connected to the CV4026 with the yellow cable. This
type of arrangement is often referred to as a slave monitor,
since both monitors display the same image.
Optional wireless headphones
The ClearVue Series II monitors have an infrared wireless
headphone transmitter built in. This automatically transmits
any audio signals routed into the CV4026 audio input RCA’s -
however, no headphones are included in the kit. These
optional headphones are available from your Rosen authorized
dealer.
A/V
outputs to
FM mod &
second
monitor
A/V inputs #2
DIN connector
to yellow cable
(to CV II
monitor)
Four-pin
wiring
harness
connector
RCA connector color code:
Yellow: Video signal
Red: Right-channel audio
White: Left-channel audio
A/V inputs #1
Wiring the System
Connecting the System