Filter
Top Products
3 Alignments and Adjustments
3-2
3-4 Service Function Spec.
3-4-1 How to Display Service Function OSD
1. After setting both brightness and contrast to '0' push the 'enter' button more than
5 seconds.
2. service function appear as below.
3-4-2 How to Control Service Function OSD
1. Monitor On Time : Power on time
2. Panel Cycle : Panel on/off time(Power off, mode change, DPMS on/off..)
3. Panel : Panel on time
(Each time the panel is replaced press the menu key for 5 seconds to add to the
Ch. No. indicating the number of time the panel has been changed.)
4. Upper lamp : Upper lamp on time
(When the upper lamp is replaced press menu to add to the Ch. No. which shows the number of times
the lamp has been replaced.)
5. Lower lamp : lower lamp on time
(When the upper lamp is replaced press menu to add to the Ch. No. which shows the number of times
the lamp has been replaced.)
6. Auto auto : If Auto auto menu set to on, when the mode is changed for the first time, Auto adjust function
is performed. Default is on
7. Pixel Shift : Not used
8. Country : OSD language can be changed with this menu to World wide, Korean, China, or Japanese.
You can navigate the menu with "+"key, and adjust with "menu key" pressing 5 seconds(Panel, Upper
Lamp, and Lower Lamp memu). You can also control Auto auto, Pixel Shift, and country menu with
pressing "-"key.
Figure 2.