Sanyo ECD-T1535 Car Stereo System User Manual


 
7
The adjustment mode will change in the following order:
By pressing VOL button + (11) or VOL button – (12), it is possible to adjust the
desired sound level.
LOUDNESS
Press BND/LOU button (13) for several seconds to reinforce the bass output and
display will show “LOUD”. Press it for several seconds again to release this function.
SET THE CLOCK
Press the DSP button (15), the clock is shown on the LCD display. Then hold down
the button until the clock flashes. Then press the MANU/SKIP
button (17) to
change hours or MANU/SKIP button
(16) to change minutes.
SELECT MODE
Press MOD button (6) shortly to choose desired listening mode.
[e.g. radio mode to CD mode to AUX mode]
MUTE
Press MUT button (3) to mute the sound instantly. If any button is pressed in the
mute state, the mute mode is released.
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated functions on the display (8).
EQUALIZATION
Press EQ button (19) to turn on equalization function and to select desired audio
mode. There are five kinds of mode as below:
AUXILIARY INPUT
The unit can be connected to a portable audio player through the AUX IN jack (24).
To hear the input signal, press MOD (6) button several times until the display shows
“AUX”.
FLASHING LED
If the front panel is not installed in the main unit, the LED (25) will be flashing.
RESET
RESET button (26) can be activated with either a ball point pen or thin metal
object. RESET button (26) is to be activated for the following reasons:
- Initial installation of the unit when all wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
FLAT CLASSICS POP M ROCK M DSP OFF
Volume Bass Treble Balance Fader