Filter
Top Products
26
E
n
MONITOR
MONITOR
Select the installation direction of the monitor.
LANDSCAPE ............Landscape orientation
PORTRAIT ...............Portrait orientation
OSD H-POSITION
Adjusts the horizontal display position of menu screen.
OSD V-POSITION
Adjusts the vertical display position of menu screen.
STANDBY MODE
When STANDARD is selected, startup/return time from standby mode/input signal waiting mode is reduced. Note, however
that, more power will be consumed in standby mode/input signal waiting mode.
When LOW POWER is selected, current consumption is reduced while the monitor is in standby mode/input signal waiting
mode. Note, however, that the startup/return time from standby mode/input signal waiting mode becomes longer.
If set to LOW POWER, only certain RS-232C commands can be used in standby mode/input signal waiting mode, and while
the monitor is in standby mode, control via LAN will be disabled (See pages 33 and 45.). Depending on the input signal, the
monitor may not switch to input signal waiting mode and may not return from input signal waiting mode.
OFF IF NO OPERATION
Determines whether or not to set the monitor to go into standby mode when there is no operation from the remote control unit,
RS-232C commands, or LAN for over 4 hours.
POWER ON DELAY
If SET is set to ON, you can delay the screen display after the monitor is turned on. When ON is selected, set the delay time
with INTERVAL (interval can be set up to 60 seconds in units of 1 second).
When this function is activated, the power LED ashes (at approx. 1 second interval) in orange.
SELF ADJUST
On a D-SUB[RGB]/DVI-I (analog) screen, specify whether to perform screen adjustment automatically or not.
When ON is selected, the screen is automatically adjusted when its resolution is 800 x 600 or higher and the timing of input
signals changes. “ADJUSTING” appears on the screen during the adjustment.
If SELF ADJUST is set to ON, set the time it takes to start the SELF ADJUST function in START TIMING.
For images with black edges, etc., depending on the signal, adjustment may not be possible. In this case select OFF. (Perform
manual adjustment of the screen.)
Menu Items