Filter
Top Products
KDL-32EX700/40EX700/40EX703/46EX700/46EX701/46EX703/ 24
52EX700/52EX701/52EX703/60EX700/60EX701/60EX703
SERVICE ADJUSTMENTS
2-2. ADJUSTMENTS AFTER REPLACING THE BAL BOARD
OR LCD PANEL
The following procedures must be completed after replacing the BAL
Board or the LCD panel.
Update the TV to the latest software version
Select the Model
Select the Destination
Verify model and panel information are correct
Reconnect all cables
2-2-1. UPDATING THE SOFTWARE
After replacing the BAL Board or the LCD Panel, you must update the
software to the latest version.
Before you begin
Disconnect all cables (RF, External input, Ethernet, etc.)
from the TV
Instructions for updating the software are included with the software
package. After completing the software update, proceed to “Selecting
the Model”.
2-2-2. SELECTING THE MODEL
After replacing the BAL Board or LCD Panel, go into Service Mode to set
the Model data value.
1. TV must be in standby mode. (Power off).
2. Access Service Mode.
Press the following buttons on the Remote Commander
within a second of each other:
DISPLAY
Channel
5
Volume
+
POWER
3. Display the DIGITAL Service Menu.
NOTE: There are 3 Service Menus for this model, DIGITAL,
CHASSIS, and SUB. If the DIGITAL Service Menu is
not displayed, press
JUMP
or
OPTIONS
on the Remote
Commander.
DIGITAL SERVICE
001 OP
000VERS ---
<MAIN> <SUB>
DM1.301J00AA SM1.010W00AA
M2.105C SB1.000W00AA
DD1.016J00AA SD1.010W00AA
(DM1.301J00AA) RF01.05
WP00.521J00AA ID1C117081
ID1C117081 LTY320AB01
PID04020000
WF:2.0.0.99 <BEM>
WF:0B BM1.012W00LU
Camera FW BB1.000W00LU
Camera FW BD1.011J46LUX
---.---------
4. Press
2
to move to the 002 MODEL (Next) category.