Filter
Top Products
CDCX517MX417/X317(YU)-total-En-5
ENGLISH
4
ENGLISH
4
Local mode
Local mode allows you to tune in only to strong stations
during Seek Tuning.
1 Press LO before you start seek tuning.
“LO” appears in the display.
To return to Distant mode, press LO again.
“LO” disappears and the unit tunes in to all receivable
stations.
Using preset stations
You must preset stations before you can tune in a station
using preset station number buttons.
Preset station
number
Presetting stations automatically
(Auto Memory)
1 Press FNC repeatedly to select the desired band
(FM1, FM2, FM3, AM1 or AM2).
2 Press and hold PS/A.ME until automatic presetting
starts.
The unit automatically stores up to 6 stations for
each band.
After completion of automatic presetting, the unit
tunes in to the station stored on preset station
button 1.
To cancel automatic presetting, press PS/A.ME again.
Checking the preset stations (Preset Scan)
1 Press PS/A.ME briefly.
Each preset station will be tuned in for 5 seconds in
order.
To cancel Preset Scan, press PS/A.ME again or any
preset station button.
Presetting stations manually
(Manual Memory)
1 Press FNC repeatedly to select the desired band
(FM1, FM2, FM3, AM1 or AM2).
2 Press TUNEi or TUNEk to tune in to a desired
station (see “Tuning in to a station,” page 3).
3 Press the desired preset station button until the unit
beeps.
Note
A newly preset station replaces the station on the same
band that was previously stored on that preset station
button.
Tuning in to a preset station
1 Press FNC repeatedly to select the desired band
(FM1, FM2, FM3, AM1 or AM2).
2 Press the preset station button on which the desired
station is stored.
Active tuning reception control (ATRC)
The unit automatically suppresses FM noise caused by
vehicle movement, and maintains sound quality.
Using the timer
(My Information)
You can schedule the radio to activate for daily radio
programs. The unit automatically turns on and off in
Radio mode at the scheduled times.
Setting the timer
1 Turn off the unit.
2 Press and hold INFO until “PO” flashes in the
display.
3 Press SEL.
4 Set the time you wish the unit to turn on.
• Press TUNEi and turn the Smart Jog to set the hour.
• Press TUNEk and turn the Smart Jog to set the
minute.
5 Press SEL.
6 Press FNC to select the band.
7 Press TUNEi, TUNEk or the desired preset station
button to select the station.
8 Press SEL.
9 Set the time you wish the unit to turn off following the
same procedure used in step 4.
Preset station buttons 1 ~ 6
MY INFO indicator
Smart Jog
001/CDC-X517M/X417/X317(YU)E 00.12.25, 2:45 PM5