Filter
Top Products
7
EN
SUB
1 0
SUR EQ
Adjusting the level of the
subwoofer(s)
— Sound Control Mode
You can adjust the subwoofer level
independently of the speakers.
1 Press (SOURCE) to select a source (radio,
tape, CD or MD etc.).
2 Press (SOUND) repeatedly until “SUB”
appears.
3 Rotate/Press (+) or (–) to adjust the
level.
After three seconds, the display goes back
to the normal playback mode.
Tip
To adjust the cut-off frequency of the subwoofer(s), press
(SOUND) for two seconds within theree seconds after
following step 3. The go to step 3 to 4 of “Adjustin the cut-
off frequency.”
Level
Cut-off frequency
Frequency (Hz)
50 62 78 99 125157
Low Pass Filter (Subwoofer)
High Pass Filter (Front, Rear)
Level
Cut-off frequency
78 99 125 157 198
Frequency (Hz)
DSP
Adjusting the cut-off
frequency — Crossover Network (CNW)
— Sound Tuning Mode
To match the characteristics of the connected
speakers or subwoofer(s), you can cut the
unwanted high, middle and low frequency
signals entering the speakers or subwoofer(s).
By setting the cut-off frequency (see the
diagram below), the speakers will output only
the most suitable frequency signals so that you
can get a clearer sound image.
1 Press (SOUND) for two seconds.
2 Press (SOUND) repeatedly until “CNW”
appears.
continue to next page n
CNW
Cut off
SUB125Hz
SUR EQ