Filter
Top Products
NSR-1000 Series v1.1.1 Release Note
values diffe
rent from actual ones when making configurations for the
cameras/camera servers shown below (V11R:483)
SNC-RH series
SNC-RS series
SNT-EP series
SNT-EX series
In this case, perform the adjustment of the detection area size while viewing
on the frame in the configuration screen.
・ When parameters in the Video setting tab are changed while recording, it will
affect the recording like the followings. (V11N:155)
Manual Record
All parameters in the Monitoring are reflected to the recording.
Schedule Record, Event/Alarm Record
・ In case Codec is changed
The change is reflected to the recording.
By this change, if a combination of settings in the Schedule tab become
inappropriate, settings in the Video tab are reflected to the recording
automatically.
However the internal change will not reflected in the Schedule tab.
・ In case Size/Bitrate/Framerate is changed
・ In case "Device Setting" is set in the Schedule tab
The change is reflected to the recording.
・ In case settings are already specified in the Schedule tab
Settings in the Schedule tab are given priority to the Video tab.
And the settings are reflected when the schedule starts.
・ When registering many (e.g. 64) cameras with Multiple Camera Registration at
one time, NSR performance becomes worse for a while. In such condition, if you
log off NSR and log on again, it may fail. Please wait several minutes after
- 14 -