Precautions
•Choose the installation location carefully so
that the unit will not interfere with normal
driving operations.
•Avoid installing the unit in areas subject to
dust, dirt, excessive vibration, or high
temperatures, such as in direct sunlight or near
heater ducts.
•Use only the supplied mounting hardware for
a safe and secure installation.
Mounting angle adjustment
Adjust the mounting angle to less than 60°.
Extended portion of the front
panel (4)
How to detach and attach the
front panel (5) (CDX-M730
only)
Before installing the unit, detach the front
panel.
5-A To detach
1 Press (OPEN) on the unit for 2 seconds.
The front panel automatically tilts at an angle
of 30°
2 Detach the front panel as illustrated.
After the front panel is completely detached,
the sub display closes automatically.
5-B To attach
Place the front panel on the front side of the unit
as illustrated, then lightly push the front panel
into position until it clicks.
Mounting example (6)
Installation in the dashboard
When installing this unit, be sure to close the
front panel of the unit. (6-
*
)
If the front panel is opened while installing and
given too much force, it may cause a
malfunction.
Mounting the unit in a Japanese
car (7)
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult
your Sony dealer.
Note
To prevent malfunction, install only with the
supplied screws 4.
Warning when installing in a car
without ACC (accessory)
position on the ignition key
switch
Be sure to press (OFF) on the unit for two
seconds to turn off the clock display after
turning off the engine.
When you press (OFF) only momentarily, the
clock display does not turn off and this causes
battery wear.
RESET button (8)
When the installation and connections are
completed, be sure to press the RESET button
with a ballpoint pen, etc.
•
•
•
4
5
5
(OPEN)
5
6
6
*
7
4
(OFF)
(OFF)
8