Filter
Top Products
13
EN
Other Functions
Using the rotary
commander
The rotary commander works by pressing
buttons and/or rotating controls.
You can control an optional CD or MD unit
with the rotary commander.
By pressing buttons (the SOURCE
and MODE buttons)
Each time you press (SOURCE), the
source changes as follows:
TAPE n TV* n TUNER n CD n MD
* When an optional TV tuner or video is
connected.
Pressing (MODE) changes the operation
in the following ways;
• Tape playback direction
• Tuner : FM1 n FM2 n AM
• CD unit : CD1 n CD2 n …
• MD unit : MD1 n MD2 n …
• TV/Video : TV n VIDEO1 n VIDEO2 n …
Tip
When the POWER SELECT switch is set to position
B, you can turn on this unit by pressing (SOURCE)
on the rotary commander.
(SOURCE)
(MODE)
Radio/Other Functions
Locating a station by
name — List-up
1 Press (LIST) momentarily.
The name assigned to the station currently
playing appears in the display.
2 Press (LIST) repeatedly until you find the
desired station.
3 Press (6) (ENTER) to tune in the desired
station.
Note
Once the station name or frequency has been
displayed for five seconds, the display goes back to
its normal mode. To turn off the display, press
(DSPL).
ENTER