Filter
Top Products
9
`/1
V/v
INPUT
MODEMENU
INPUT
ATT
`/1
VOL
VOLUME
＋/−
POWERINPUT
Operation
Selecting the input source
You can select the input source.
1 Press (POWER).
On the card remote commander, press
{/1
.
The power is turned on.
2 Press (INPUT) to select the desired input source.
Each time you press (INPUT), the indication changes in the following sequence:
VIDEO 1 VIDEO 2
RECEIVER
*
Note
If you use the monitor with the rechargeable battery (MV-100BAT) (optional), the
monitor automatically enters into the receiver mode when turned on. The (INPUT)
button is deactivated and the input source is fixed to the receiver mode. See “Using the
rechargeable battery” (page 15).
* Note on wireless transmission (Receiver mode)
Simultaneous use with other 2.4 GHz equipment may cause image interference or
audio noise. This is not a malfunction, but a result of equipment sharing the same
operating frequency.