Filter
Top Products
66
GB
D:\NORM'S JOB\SONY HA\SO120006\STR-
DH720_PMRF_05\4262412122_GB\GB05ENJ_STR-DH720-CEL.fm
masterpage: Left
STR-DH720
4-262-412-12(2)
Tips
• To adjust the level of all speakers at the same time,
press MASTER VOL +/– or
2 +/–. You can also
use MASTER VOLUME on the receiver.
• The adjusted value is shown on the TV screen
during adjustment.
To output test tone from each
speaker
You can output test tone from the speakers in
sequence.
1 Select “Test Tone”, then press or b.
2 Adjust the parameter, then press .
•OFF
•AUTO: The test tone is output from each
speaker in sequence.
3 Adjust the speaker level, then press
.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely. Check to see if they are connected
securely and cannot be disconnected by
pulling on them slightly.
• The speaker cords may have short-circuit
problem.
When a test tone is output from
a different speaker than the
speaker displayed on the TV
screen
The speaker pattern set up is incorrect. Make
sure that the speaker connections and the
speaker pattern match correctly.
x D.Range Comp (Dynamic range
compression)
Lets you compress the dynamic range of the
soundtrack. This may be useful when you want
to watch movies at low volumes late at night.
Dynamic range compression is possible with
Dolby Digital sources only.
• MAX: The dynamic range is compressed
dramatically.
• STD: The dynamic range is compressed as
intended by the recording engineer.
• AUTO: The dynamic range is applied
automatically with Dolby TrueHD source or
other source is set to “OFF”.
• OFF: The dynamic range is not compressed.
Tips
• Dynamic range compressor lets you compress the
dynamic range of the soundtrack based on the
dynamic range information included in the Dolby
Digital signal.
• “STD” is the standard setting, and enacts light
compression. Therefore, we recommend using the
“MAX” setting. This greatly compresses the
dynamic range and lets you view movies late at
night at low volumes. Unlike analog limiters, the
levels are predetermined and provide a very natural
compression.
x Distance Unit
Lets you select the unit of measurement for
setting distances.
• FEET: The distance is displayed in feet.
• METER: The distance is displayed in
meters.