Filter
Top Products
11
(GB)
5 Press the + or – button to select the channel.
Pressing the + button cyclically changes the channels of
the group selected in step 3 in the listed order in the
respective table in the “Wireless Microphone System
Frequency List ” supplied with this manual.
Pressing the – button changes them in the reverse order.
When you reach the last channel in the group, press the +
button to return to the first channel in the group.
Likewise, press the – button to go from the first channel
to the last channel.
6 After the desired channel is displayed, leave the unit for
5 seconds without pressing any buttons.
Channel selection mode is automatically canceled and
the channel shown on the display is set.
When the group 00 is selectedfor U66 model
Storing the group and channel
The selected group and channel set by the above procedure
are stored in memory when the display stops flashing.
Notes
To eliminate interference or noise, please note the
following.
•
Do not use two or more wireless microphones or
transmitters whose wireless channels are the same.
•
If there is a TV broadcasting station nearby, to avoid
possible interference from its broadcast, do not use that
station’s channel.
•
The number of wireless channels actually usable in a
multi-channel system may be smaller than the normal
capacity of that system if there is interference from TV
broadcasting or other RF signals.
• To operate two or more UHF synthesized wireless
microphones/transmitters using the same wireless channel
of the same group, ensure that the wireless microphones/
transmitters are at least 100 m (330 feet
)
1)
apart as far as
they are installed within sight of each other.
• When using two or more WRR-855A/855Bs, do not
directly put one unit upon the other.
.........................................................................................................................
1) The distance depends on the operating environment and conditions.