Filter
Top Products
12
EN
Other Functions
Using the rotary commander
The rotary commander works by pressing
buttons and/or rotating controls.
You can control the optional CD/MD unit by
the rotary commander.
By pressing buttons (the SOURCE
and the MODE buttons)
Every time you press (SOURCE), the
source changes as follows:
TAPE n TUNER n CD n MD
Pressing (MODE) changes the operation in the
following ways:
• the tape transport.
• the band, FM1 n FM2 n FM3 n MW n LW.
• the CD/MD unit.
Tip
You can turn on this unit by pressing (SOURCE) on the
rotary commander.
By rotating the control (the SEEK/
AMS control)
(MODE)
(SOURCE)
Rotate the control momentarily and
release it to:
• Locate the beginnings of the tracks on the
tape. Rotate and hold the control, and
release it to fast-wind the tape. To
playback, rotate and hold the control
again, and release it.
• Locate a specific track on a disc. Rotate
and hold the control until you locate the
specific point in a track, then release it to
start playback.
• Tune in the stations automatically.
Rotate and hold the control to tune in the
specific station.
By rotating the control while
pushing in (the PRESET/DISC
control)
Push in and rotate the control to:
• Receive the stations memorized on the
preset buttons.
• Change the disc.
Other operations
Press (OFF) to
turn off the unit.
Press (SEL)
to adjust
and select.
OFF
Press (ATT)to
attenuate the
sound.
Rotate the VOL control
to adjust the volume.
XR-C6100R:
Press (FILE) for two seconds
to change the Disc memo.
XR-C5100R:
Press (DSPL) to change the
displayed items.