Filter
Top Products
(
INSTALLATION STEP 3
]
WIRING
POWER
AND
GROUND
To ensure maximum output from your
RUBICON
amplifier, use high quality, low-
loss
power and ground cables and connections. The
RUBICON
amplifiers will
accept up to 4 gauge power and ground cables. Determine from the chart below
the minimum gauge power and ground wire for your application.
I
I
up
to
10’
I
up
to
20’
I
REMOTE TURN-ON
Connect the “Remote” line to the turn-on lead from the source unit. When
+12
Volts is received, the amplifier will turn on.
Use a high quality cable that will be easy to install and has minimal signal loss
guarantee optimum performance.
The
RUBICON
amplifiers will accept up to 8 gauge speaker cable.
Use a high
quality, flexible, multi-strand cable for best performance and longevity.
RUB/CON Amplifier Fuse Values
SIGNAL CABLE
RUBICON
502
4
or 8 gauge
4
gauge only
RUB/CON
702 4
or 8 gauge
4
gauge
only
I
RUB/CON
1002
4
gauge only
4
gauge only
I
Amplifier Fuse
I
Battery Fuse
/
Circuit Breaker
I
I
RUBICON
502
I
(2) 30 amp automotive
I
80 amp
I
I
RUB/CON 702
I
60 amp Maxi-fuse
T
80 amp
-1
SPEAKER CABLE
CIRCUIT BREAKERS AND FUSES
EXTERNAL
Like all audio components, the RUBICON amplifiers must be fused near the
battery. A fuse or circuit breaker must be located within 18” of the
batterv.
This will
Fuse
1
at the
prevent a fire in the event of a shorted cable.
See the chart below to determine the
Battery
”
correct fuse value.
INTERNAL
The
RUBICON
amplifiers are fused with an automotive-type or Maxi-fuse. In the
event of a blown power supply fuse(s), replace with the correct value fuse found in
the chart below. Never replace the fuse with a higher value than what is sup-
plied. This may result in amplifier damage and will void the warranty1
I-
+
To
+lZV
Battery
Terminal
To Chassis
Ground
I
’
To 2nd
Amplifier
I_
(optIona<)
SPEAKERS
[Head Unit
iw
1
to
1
RUB/CON 1002
1
80 amp Maxi-fuse
100 amp
14
15