Filter
Top Products
BassX-W10 Owner’s Manual Page 7
AC Plug Cord
Line Inputs
Volume Limit
Control
Fuse
Low Pass
Crossover
Control
Serial Number
Speaker Inputs
Speaker Outputs
LFE Input
Line
Outputs
Bass
Boost
Control
Phase Switch
Subwoofer
Outputs
Power Switch
2. Installation of BBXW10
Please use Diagram 2 to familiarize yourself with the rear panel of the BBXW10.
a. Auto Sense Power On
• The amplifier is turned on and off by sensing audio signals coming from the receiver or pre-amp through the input
connections.
• NOTE: The amplifier’s front power switch must be turned on for the Audio Sense mode to operate. Once the power
is switched on, the auto sense mode automatically is activated. The “Active” LED on the front of the amplifier will
not light up until an audio signal is sensed. The amplifier will then be operating. At the moment that either the
Left, Right line level input jacks, the speaker input connectors or the LFE input jack receive a signal, the amplifier will
then turn on. Once the signal stops, the amplifier will turns off in a few minutes. If you will be away for a long period
of time, you may wish to turn off the main power switch or unplug the unit from the outlet.
b. Connecting the Subwoofer to the Amplifier
• CAUTION:
Only make connections when the amplifier is turned off.
• You MUST use a minimum of 14 gauge speaker wire. There are 2 outputs on the amplifier, one positive and one
negative outputs. The 3-way binding post outputs on the back of the amplifier allow for a variety of ways to connect
your subwoofer to the amplifier, including stripped wire, spade connectors, etc.
DIAGRAM 2
BBXW10 Rear Panel