Filter
Top Products
Instruction Manual
3
DSRXL Receiver Installation
1. Place the DSRXL Receiver unit near the remote video display device 1. and connect
the power adapter to the Receiver unit.
2. Connect the Receiver unit’s “Monitor 1” VGA connector to the video 2. display device
with a standard male/male VGA cable. If using audio, connect the audio receiver/
speakers to the “Audio” connector for “Monitor 1”, using a 3.5mm mini-jack cable.
OPTIONAL: Connect the serial controlled device (i.e. the display device) to the RS232
DB9 connector for “Monitor 1”.
NOTE: A second set of devices can be connected to a single Receiver unit, by
connecting them to the “Monitor 2” connectors.
3. Connect the UTP cable from the Transmitter unit to the “System In” 3. connector on
the Receiver Unit.
NOTE: Receiver Units can be daisy-chained together by connecting a UTP cable from
the “System Out” connector to the “System In” connector on another Receiver Unit. Up
to 5 levels of Receiver Units can be chained together.
4. Repeat previous steps for each Receiver unit that needs to be set 4. up.
5. Once all receiver units are setup, power on the devices connected to 5. the Receiver
units and then power up the devices connected to the Transmitter unit.
Driver Installation
This Extender is a complete hardware solution, so is normally invisible to any other
devices. No driver installation is required for use.