Filter
Top Products
42
Troubleshooting
If you have problems with your system, look through
this chart and see if you can solve the problem
yourself before calling your dealer or TEAC service
center.
General
No power
e
Check the connection to the AC power supply.
Check and make sure the AC source is not a
switched outlet and that, if it is, the switch is
turned on. Make sure there is power to the AC
outlet by plugging another item such as a lamp or
fan into the outlet.
No sound from speakers.
e
Select the source by pressing the SOURCE button.
e
Check the connection to the speakers.
e
Adjust the volume.
e
Pull out the headphone’s plug from the PHONES
jack.
e
If “MUTE” is blinking, press the MUTING button.
The sound is noisy.
e
The unit is too close to a TV or similar appliances.
Install the unit apart from them, or turn them off.
Remote control doesn’t work.
e
Press the STANDBY/ON switch to turn the unit on.
e
If the batteries are dead, change the batteries.
e
Use remote control unit within the range (5m or
16 ft.) and point at the front panel.
e
Clear obstacles between the remote control unit
and the main unit.
e
If a strong light is near the unit, turn it off.
CD Player
Will not play.
e
Load a disc with label side up.
e
If the disc is dirty, clean the surface of the disc.
e
A blank disc has been loaded. Load a prerecorded
disc.
e
Depending on the disc, etc. it may not be possible
to play back CD-R/RW discs. Try again with
another disc.
e
You cannot play back unfinalized CD-R/RW discs.
Finalize such a disc in a CD recorder and try again.
Sound skips.
e
Place the unit on a stable place to avoid vibration
and shock.
e
If the disc is dirty, clean the surface of the disc.
e
Don’t use scratched, damaged or warped discs.
MP3/WMA
There is no sound even if the PLAY button (y) is
pressed.
e
Check the file format. Non-playable file formats
(e.g MPEG 1 LAYER 2 file) cannot be played.
“No song title No artist No album’ appears on the
display.
e
There is no ID3 tag information for the music file.
Edit the song title, artist, and album information
of the song on a PC using the MP3 or WMA
making application.
Some unknown characters are displayed on the
display panel.
e
This unit cannot display symbols and full-size or
double-byte characters (such as Japanese,
Chinese, etc.) correctly. File name of MP3 or
WMA should be alphanumeric characters.
iPod Player
Cannot insert the iPod.
e
Check the dock adapter.
e
Remove dust or obstacles from the Dock
connector of the CR-H227i and the iPod, and
insert the iPod again.
Will not play.
e
Remove the iPod from the dock, wait a few
seconds, and insert it again.
e
Software update may solve the problem. Visit the
Apple website and download the latest iPod
Software.
Tuner
Cannot listen to any station, or signal is too
weak.
e
Tune in the station properly.
e
Rotate the FM or AM antenna for the best
reception position.
e
An external antenna is recommended.
Though the broadcast is stereo, it sounds
monaural.
e
Press the FM MODE button.
If normal operation cannot be recovered, unplug
the power cord from the outlet and plug it again.