Filter
Top Products
Troubleshooting guide
Before requesting service for this unit, check the chart below for
a possible cause of the problem you are experiencing. Some sim-
ple checks or a minor adjustment on your part may eliminate the
problem and restore proper operation.
If you are in doubt about some of the check points, or if the
remedies indicated in the chart do not solve the problem, refer to
the directory of authorized service centers (enclosed with this
unit) to locate a convenient service center, or consult your
Technics dealer for instructions.
(In U.S.A. consult MSC Authorized Servicenters for detailed in-
structions.)
I
Problem Probable cause(s)
Changer will not play.
The disc in the changer
does not play.
Play stops before changing
to the next disc.
A certain music passage
can't be played correctly.
These is noise from the
tuner or disturbance on the
TV screen.
When program play is
started, an error message
(-E) appears on the
display.
An error message (- E)
appears on the display, and
the changer stops
operating.
The loading drawer stops in
the middle o! opening.
A disc(s) or other foreign object(s) has fallen
inside the changer.
Moisture has collected in the changer.
The disc is upside down.
The disc is dirty.
The disc is scratched.
]-he disc is warped.
The disc is not within specified standards.
The loading drawer is open.
The disc is dirty.
The disc is scratched.
Caused by high-frequency signals from this
changer.
Play was started without a track being
programmed.
The mechanism of the changer has been
improperly adjusted.
Suggested remedy
• Open the loading drawer, and then remove the
object.
• Switch on and allow the changer to dry out for about
one hour before using it.
• Make sure the label is facing upward.
• Wipe the disc with a soft cloth.
• Replace the disc with a new one.
• Press the OPENtCLOSE button to close the loading
drawer.
• Wipe the disc with a soft cloth.
• Replace the disc with a new one.
• Use the changer further away from the tuner or TV.
• If the tuner or TV's antenna is the indoor type, use an
outdoor one.
• Program a track.
• Turn the unit off and then back on again.
However, if the loading drawer is fully open, take out
the compact disc(s) at the front position and then turn
the unit off and then back on again.
I
Product service
Do not attempt to remove the cover(s) or repair the unit
yourself.
Refer servicing to qualified personnel only.
Product information
For product service, product information or assistance in pro-
duct operation, refer to the servicenter directory.
19