Filter
Top Products
6
Connections
Loudspeakers
Check the impedance of your speakers. You can use types with an
impedance of between 4 and 8 Ohms.
The red coloured speaker terminals are positive (+) and the black speaker
terminals are negative (-). Make sure correct polarity is maintained at
each speaker connector or the sound can become weak and “phasey”
with little bass.
Using bare wire connections
Prepare the speaker cords for connection by stripping off approximately
10mm (3/8”) or less of the outer insulation. More than 10mm could
cause a short circuit. Twist the wires tightly together so there are no loose
ends. Unscrew the speaker terminal, insert the speaker cable, tighten
the terminal and secure the cable.
Topaz AM1/AM5
Right
speaker
Left
speaker
CD player
Red
Black Red Red Black
Black
RedBlack
Note: All connections are made using standard loudspeaker cable.
The diagram below shows the basic connection of your amplifier to a CD
player and a pair of loudspeakers.