Toshiba 42WL55A Car Satellite TV System User Manual


 
3
Introduction
Getting started
Basic operation
Features
Equipment
connections
Reference section
Viewing teletext
Be sure to observe the following instructions and precautions to ensure safe use of this TV.
The exact power cord will vary according to the country or region.
Installation
Introduction
Important Safety Instructions
Always connect the power plug to an electrical outlet equipped with
A model: 220-240V, AC 50Hz, E model: 220-240V, AC 50/60Hz and T
model: 110-240V, AC 50/60Hz.
Do not use the TV outside the specified voltage range. It may cause a fire
or an electric shock.
WARNING ABOUT THREE-WIRE GROUNDING-TYPE PLUG:
Do not remove the earthing pin on the power plug. This system is
equipped with a three pin earthing-type power plug. This plug will
only fit an earthing-type power outlet. This is a safety feature. If you
are unable to insert the plug into the outlet, contact an electrician to
replace the wall outlet.
Do not defeat the purpose of the earthing plug.
Never insert or remove the power plug with wet hands.
This may cause electric shock.
Do not place the TV in an unstabilized location such as on a shaky
table, incline or location subject to vibration.
The TV may drop or fall down which may cause injury or damage.
The slots and openings in the cabinet must never be blocked or
covered.
• Do not place the TV so that it is facing upwards, or on its side.
• Do not place the TV into a closet or bookshelf where the ventilation is
poor.
• Do not spread a newspaper, tablecloth or curtain on the TV.
• When installing the TV against a wall, keep the TV at least 10 cm from
the wall.
• Do not place the TV on an unstable object, such as a carpet, or a
cushion, etc.
The inside of this TV will overheat if the ventilation holes are sealed,
which may result in a fire.
Never place the TV near a heater.
The surface of the cabinet or power cord may melt and result in fire or
electric shock.
Check!
About the fuse
In a three pin earthing-type, the fuse fitted
in this plug is approved by ASTA or BSI to
BS1362. It should only be replaced by a
correctly rated and approved type and the
fuse cover must be refitted.
Ex. 220-240V AC, 50/60Hz