Uniden Bearcat 880 Car Satellite Radio System User Manual


 
11
scanning in the selected direction.
To change to Memory Channel Scan mode, press MEM/SCAN
while in All Channel Scan mode (see page 12).
3. To exit All Channel Scan mode, press PTT, 9/19/NORM, WEATHER,
or CB/PA.
WEATHER MODE WX MODE
Your radio combines a CB radio with a Weather radio and a Weather Alert
system. The Weather Alert system sounds a seven-second signal in the
event of severe weather when you are in CB mode. The Weather radio
continually broadcasts weather conditions when you are in Weather
mode.
1. Press WEATHER. Your radio is now in Weather radio mode.
2. Select 1 of 7 weather channels using Channel Selector.
You cannot change ANL or NB settings while in WX mode. The radio will sound an
alert tone.
Set Weather Scan Mode
Weather Scan mode allows the radio to move to the next weather
channel if no signal is detected after 3 seconds. Set Weather Scan mode
to ON or OFF through the menus.
1. Press MENU/OK to activate the menus. COLOR displays.
2. Turn the Channel Selector knob to cycle through the menu op-
tions until WXSCAN displays.
3. Press MENU/OK. ON displays.
4. Press MENU/OK to set Weather Scan mode to ON or turn the se-
lection knob until OFF displays and then press MENU/OK to set it.
WXSCAN displays again.
If Weather Scan is ON when you turn o the radio, it remains ON.
Left at these setting (WX mode, WX Scan), you will hear only
weather broadcasts and Weather Alert signals. To use your CB radio
normally while monitoring weather alerts, press WEATHER again.