Filter
Top Products
This section addresses EQ setup and day-to-day usage of your SC-600D amplifier.
R e m ot e C o n t r o l
The features of the SC-600D remote control are listed below.
• POWER — This button forces your SC-600D amplifier unit into
standby mode. The power LED turns amber, the numeric LED
shuts off, and the amplifier puts out no power. The unit will
remain in this mode until the POWER button is pressed again.
To fully deactivate (i.e. power down) the unit, use the main
power switch on the back panel.
Note: The master power switch on rear panel must be on in
order for the front power button to function.
• MUTE — This button mutes the subwoofer’s output. The LED
on the amplifier will show 00 if the unit is muted. To unmute
the subwoofer, press the MUTE button again and the original
volume setting shows on the LED.
• EQ — This button automatically EQs the subwoofer using a 5-band internal graphic equalizer.
To use this feature, first plug the supplied microphone into the Mic-In jack on the front panel
of the amplifier and place the mic in your preferred listening position. Then press EQ on the
remote for about 2-3 seconds. The subwoofer emits 12 “sweep tones” that cover the
frequencies between 20 and 150 Hz. The LED displays “AU” during the Auto-EQ process.
After the sweeps are complete, the unit saves its EQ settings and returns to normal
operation. To prevent accidental invocation of the EQ feature, you must hold down the EQ
button for 2-3 seconds before the EQ sweeps begin.
Note: Each time the EQ feature is utilized, the EQ settings for the SC-600D amplifier are reset.
If the microphone is not plugged in, the SC-600D amplifier will emit one or two sweep tones
then cease the EQ operation. In this case, the previous EQ settings will be preserved.
• PHASE —
T
hese buttons allow you to optimize the subwoofer performance for the location
and your listening position. Play some bass-heavy music. While listening, push one of the four
phase buttons, listen for a few moments, and then press the next phase button. In most
installations, one of the four button positions will offer an audibly better blend of subwoofer
and speakers. Selecting the correct phase position is just that easy. The LED will show the
phase selected by showing “PH” followed by the phase number: 0, 90, 180 or 270.
• LIGHT — If you wish, you can deactivate the numeric LED on your SC-600D amplifier.
To do this, press the LIGHT button on your remote. To reactivate the LED, press the LIGHT
button again.
• NIGHT — Night mode limits the maximum dynamic output of the subwoofer for late night
listening or to be more considerate of close neighbors. Press the night button to turn the
night mode feature on or off. Activation of night mode causes “n” to appear briefly on the
display. When night mode is deactivated, the display shows “n off” and then returns to
normal function.
11
w w w . v e l o d y n e . c o m
SC-600D Amplifier User’s Manual
U s a g e
Figure 5: SC-600D Remote.