Vizio CA-115 Car Amplifier User Manual


 
OPERATION
To connect the amplifier to the tape recorder, use either a
commercial "phone plug-to-miniature plug" cord or such a
connection cord as is shown below.
Solder Hot and Cold in the shielded cable correctly so that they
do not contact each other.
I SPECIFICATIONS
TOA Corporation
Note : The design and specifications are subject to change without notice for
improvement.
1. Press the power switch and ensure that the power indicator
lights. (If the power indicator does not light, check the power cord
for correct connection.)
2. Insert the microphone plug into Mic 1 input jack
3. Turn on the microphone switch and adjust the volume using Mic 1
volume control When using Mic 2, connect the microphone to Mic
2 input jack and adjust the volume with Mic 2 volume control
Up to two microphones can be used per amplifier.
4. When using a tape recorder or radio, connect the earphone terminal
or LINE OUT terminal of the tape recorder, etc. to the auxiliary input
jack by means of a shielded wire. Use the volume control of the
tape recorder, etc. to adjust the volume.
Model No.
Power Source
Current Consumption
Rated Output
Distortion
Frequency Response
Input
Dimensions (mm)
Weight
Supplied Microphone
CA-115
CA130
Standard voltage: 14 VDC
Operating range: 10 - 16 VDC (12 V battery)
Under 2.7 A
(rated output)
15W
Under 4.4 A
(rated output)
30W
Under 5% (1 kHz, rated output)
100 Hz -10 kHz within ±3 dB
Mic
1:600
, 4mV
(Usable plug: 6.3 mm phone plug)
Mic 2: 600 , 4mV
(Usable plug: 6.3 mm phone plug)
Aux: 10k , 500mV
(Usable plug: 6.3 mm phone plug)
178(w)×50(h)×121(d)
0.9kg
(amplifier only)
178(w)×50(h)×136(d)
1.1 kg
(amplifier only)
Uni-directional dynamic microphone
(with talk switch)
Impedance: 600
Sensitivity: -73 dB ±3 dB
Accessories
Dynamic microphone (with talk switch)
Microphone holder
Mounting screw (4x16)
Mounting bracket
Mounting screws
Hexagon bolt (M5×15)
Screw (M4×8)
Nut
(M5)
Spring washer (M5)
Spring washer (M4)
Plain washer (M5)
Plain washer (M4)
Power cord (1.5m)
Speaker cable (0.3 m)
Fuse (CA-115: 4 A/CA-130: 8 A)
1
1
2
1
2
4
2
2
4
4
4
1
1
1