Filter
Top Products
2
ASSEMBLY
STEP 1. Attach feed support to the backup support.
See Figures 1 & 2. Make sure spring is locked into
place.
FIGURE 3
Spring
Pin
E-Clip
Backup Support
Coax Downlead
from LNBF
FIGURE 2
Feed Support
FIGURE 1
E-Clip
Backup Support
Spring
Feed Support
After inserting pin,
swing long part of
spring up into the
feed support and
snap into place
under cable clip.
STEP 2. Remove the two top bolts from the backup
support and attach the elevation assembly to antenna.
See Figure 3. Tighten bolts securely.
Backup Support
Elevation Assembly
Slide elevation
assembly into place
Pin