Filter
Top Products
6
When using remote control
Preparing the remote control
Notes on battery
Notes on the remote control
Do not expose the remote sensor of the DVD player and the remote control to a strong light source
such as direct sunlight or other illumination. If you do so, you may not be able to operate the DVD
player via the remote control.
To operate the remote control correctly, follow the instructions below.
Do not insert cell into the remote control in the wrong direction.
Do not charge, heat, open, or short-circuit the cell. Do not throw cell into a fire.
If the remote control does not function correctly or if the operating range becomes reduced,
replace the cell with new one.
Direct the remote control at the remote sensor of the DVD player.
Do not drop or give the remote control a shock.
Do not leave the remote control near an extremely hot or humid place.
Do not spill water or put anything wet on the remote control.
Do not disassemble the remote control.
Operating with the remote control
With about 4m
1) Open the cover,
pull the cover as illustrated
2)Insert cell (3V),Close the cover
1
2
3
4
5
6
C
L
E
A
R
P
O
W
ER
D
IS
P
L
AY
R
A
D
IO
/D
V
D
0
C
L
O
CK
D
IS
P
L
AY
This section shows you how to use the
remote control. Point the remote control
at the remote sensor and press the buttons.
The remote range: about 4m from the front
of the remote sensor.
(Is) off axis: more than 30L in each direction
of the front of the remote sensor.
Insert battery (3V, CR2025) into the remote control.
Make sure the + side of the battery faces up before closing the cover.