TABM B-3
1 Launch TABM and allow the autodiscovery process to occur. Locate the
target AccessBuilder in the View All Servers list and double-click on the
unit.
2 Enter the superuser password for the selected AccessBuilder.
3 Under the TABM System menu, select the Download/Upload dialog
box.
4 Enter the appropriate IP address of the TFTP server on which you have
placed the AccessBuilder files.
5 Select the desired function from the Download/Upload dialog box by
clicking on the appropriate radio button, then click on the OK bar.
The following table lists the AccessBuilder file names associated with
each function.
In the event of a failed file transfer, a failed transfer message prompt
will be issued by the AccessBuilder.
The AccessBuilder server then resets and resumes normal operation.
The download/upload procedure is now complete.
What To Do If An
Image Download
Fails
The image download procedure is handled by the AccessBuilder’s
internal executive monitor firmware, called "nindy". Normally, when
an image download is completed, the new image is copied into Flash
memory and the AccessBuilder automatically resets. In the event an
image download fails, the AccessBuilder should reset with the old
image. There is a possibility, however, that during the download
attempt a failure could occur which would erase the old image.
Should this occur, the AccessBuilder remains in the nindy mode and
cannot automatically reset. To recover, perform the procedures on
page B-9.
Table B-1 AccessBuilder Download/Upload TFTP Filenames
AccessBuilder
Model
Software
Image
Configuration
Download
Configuration
Upload
2000 ntksrvr ntkdncfg.cfg ntkupcfg.cfg
4000 absrvr abdncfg.cfg abupcfg.cfg
ab4kbook Page 3 Thursday, March 27, 1997 11:51 AM
