Without proper lubrication the tool will not work properly and parts will wear prematurely.
z Use the proper lubricant in the air line lubricator. The lubricator should be of low air flow or changing air flow type,
and should be kept filled to the correct level. Use only recommended lubricants, specially made for pneumatic
applications. Substitutes may harm the rubber compounds in the tools O-rings and other rubber parts.
IMPORTANT!!! If a filter/regulator/lubricator is not installed on the air system, air operated tools should be lubricated
at least once a day or after 2 hours work with 2 to 6 drops of oil, depending on the work environment, directly through
the male fitting in the tool housing.
Loading and Operation
)WARNING: Ensure you read, understand and apply safety instructions before use.
1. Only use impact sockets which are specifically designed for use with an impact wrench.
2. Connect the wrench to the air hose.
3. Place the socket over the subject nut and depress the trigger to operate the wrench.
4. To change direction, push the button at the top of the handle. Direction of “R” for reverse and “F” for forward
5. The flow of air may be regulated by adjusting flow valve at the base of the handle.
DO NOT use any additional force upon the wrench in order to remove a nut.
DO NOT allow wrench to free run for an extended period of time as this will shorten its life.
Maintenance
)WARNING: Disconnect wrench from air supply before changing accessories, servicing or performing
maintenance. Replace or repair damaged parts. Use genuine parts only. Non-authorized parts may be dangerous
1. Lubricate the air wrench daily with a few drops of air tool oil dripped into the air inlet
2. DO NOT use worn or damaged sockets.
