A SERVICE OF

logo

CM1164 RS-232 Control Tool
25
DCC Control
The DCC Control command allows you to set the DCC Control mode. Use the
Formula - to set Parameters - to create a Command.
Formulas:
Command + Control + [Enter]
Parameters:
DCC Control Commands
Some available formulas for DCC Control commands are as follows:
1. Command + Control + [Enter]
For example, to set the default DCC clone mode, type the following:
dcc clone [Enter]
2. Command + Control + [Enter]
For example, to enable DCC control, type the following:
dcc on [Enter]
Note: Each command string can be separated with a space.
Command Description
dcc DCC Control Command
Control Description
clone Sets the default DCC clone mode
off Disables DCC function
on Enables DCC function
Enter Description
Enter Enter and send out command