CS82U / CS84U User Manual
12
Mouse Port-switching
The CS82U / CS84U supports the very latest in mouse port-switching – simply
double-click the scroll wheel of your USB mouse to cycle through the ports.
Note: 1. This featured is only supported by USB 3-key scroll wheel mice.
2. The default setting is disabled
3. This feature is only supported when Mouse Emulation is enabled. See
Mouse Port-switching, page 21, for details.
Powering Off and Restarting
If it becomes necessary to power off the CS82U / CS84U unit, before starting
it back up you must do the following:
1. Shut down all the computers that are attached to the switch.
2. Unplug the switch’s power adapter cable.
3. Wait 10 seconds, then plug the switch’s power adapter cable back in.
4. After the switch is up, power on the computers.
Port ID Numbering
Each KVM port section on the CS82U / CS84U switch is assigned a port
number. (1 or 2 for the CS82U; 1 to 4 for the CS84U). The port numbers are
marked on the rear panel of the switch (see page 7 for details).
The Port ID of a computer is derived from the KVM port number it is
connected to. For example, a computer connected to KVM port 2 has a Port ID
of 2.
The Port ID is used to specify which computer gets the KVM focus with the
Hotkey port selection method (see page 15 for details).
