INSTALLATION PROCEDURES
, ,
lDchoring Cable Assembly (Continued)
I Drill 114"
This Side
FIGURE 23
Anchor
t General Motors Blank Anchor
--, .
1. To locate the blank anchor on General Motors
vehicl~, jljs necessary to remove the air
cleaner. The blank anchor is located above
the throttle anchor .
2. This anchor is hollow except at one end. Use
a 114" bit and drill as shown in Figure 23.
3. Before using the 114"-20 Nut, remove the
Adjustable Sleeve from the Cable A3sembly.
Then use the 114"-20 Nut to fonD threads
on the end of the Cable Assembly. This is easily
accomplished by first placing the 114" -20
Nut on the end of the Cable Assembly with
your fingers and then use a 7116" box end
wrench and tucfn clockwise until the desired ,
amount of threads have been formed.
(Figure 19, pa&e 14)
4. Insert the Cable Assembly through the blank
anchor and thread the other 114" -20 Nut in
place. (Figure 2.4)
, -;, ,
5. The 114" -20 Nut cali .be used if there is a
pre-existing 114" hole in a bracket on the vehicle
or if it islX>SSible to drill a 114" hole in a bracket
I
on the vehicle. (FIgure 26)
Form 1#4313, Page 15
i
