6
Installation
Use the following procedures for installing your 9103 telephone.
Contents of the 9103 Package
The following items come in the box with the 9103 telephone:
• A 7-foot line cord
• A 9-foot handset cord
Installing the Batteries
This telephone requires two 1.5-Volt AA batteries (provided with the
set) to retain the numbers stored in memory in the event the telephone
is disconnected from the line.
1 If the telephone is already connected, disconnect the
telephone from the modular jack before you install the
batteries.
2 Locate the battery compartment on the right side on the
bottom of the telephone. See Figure 1 for its location.
3 Insert a small pointed tool or a small screwdriver in the
“D”-shaped hole to the left of the compartment.
4 Press down and slide the cover to the right to open it.
5 Insert two AA batteries in the battery compartment. The “–”
(negative) end of the battery should be placed against the
springs.
6 Replace the battery compartment cover and, if applicable,
plug the line cord into the modular jack again. If you have
not installed the telephone yet, go on to Desk/Table
Installation on the next page.
Note: After you replace the batteries, it will be necessary to
re-program your memory-dialing buttons.
