A SERVICE OF

logo

Open as PDF
next previous
Assembly
Step 13: Cable and Pulley Routing the Rear Pulleys
Parts
• CompletedAssembly(fromstep12)
Tools
• AdjustableWrench(notincluded)
13-1 Remove the 3/8” x 4 1/2” Hex Head Bolt and the 3/8” Washer in the center of the Lat Pulley Housing.
13-2 Remove the two pulley wheels from the Lat Pulley Housing.
13-3 Unwrap the Right Pulley Cable from the Right Frame Rail and thread it under and then over one of the pulley wheels.
Pinch the Right Pulley Cable to the pulley wheel until installed.
13-4 Unwrap the Left Pulley Cable on the Left Frame Rail and thread it under and then over the other pulley wheel.
13-5 Put the pulleys with the cables wrapped around them back into the Lat Pulley Housing.
13-6 Replace and tighten the 3/8” x 4 1/2” Hex Head Bolt and the 3/8” Washer in the center of the Lat Pulley Housing.
Assembly Manual
18